Reinstall windows after FC5
时间：2007-02-04 来源：navy319510
DOS-based solution
Boot with a DOS floppy that has "debug" on it; run "debug". At the '-' prompt, "block-fill" a 512-byte chunk of memory with zeroes:
f 9000:0 200 0
Start assembly mode with the 'a' command, and enter the following code:
mov dx,9000
mov es,dx
xor bx,bx
mov cx,0001
mov dx,0080
mov ax,0301
int 13
int 20
Press <Enter> to exit assembly mode, take a deep breath - and press "g" to execute, then "q" to quit "debug". Your HD is now in a virgin state, and ready for partitioning and installation. 这种方法可以解决fc5后重装windows，但会使磁盘数据丢失。因为破坏了分区表了。当然可以用软件恢复，但麻烦，所以用的时候要小心。
Boot with a DOS floppy that has "debug" on it; run "debug". At the '-' prompt, "block-fill" a 512-byte chunk of memory with zeroes:
f 9000:0 200 0
Start assembly mode with the 'a' command, and enter the following code:
mov dx,9000
mov es,dx
xor bx,bx
mov cx,0001
mov dx,0080
mov ax,0301
int 13
int 20
Press <Enter> to exit assembly mode, take a deep breath - and press "g" to execute, then "q" to quit "debug". Your HD is now in a virgin state, and ready for partitioning and installation. 这种方法可以解决fc5后重装windows，但会使磁盘数据丢失。因为破坏了分区表了。当然可以用软件恢复，但麻烦，所以用的时候要小心。
相关阅读 更多 +
