RE: [toaster] Different Greylisting Question, vari
时间：2006-11-22 来源：snowtty
I couldn't figure that out either....
You place a line in /var/qmail/supervise/qmail-smtpd/run
i.e. export BLOCK_EXPIRE="13"
Bill
-----Original Message-----
From: Blake Carver [mailto:[email protected]]
Sent: Tuesday, November 21, 2006 6:06 AM
To: [email protected]
Subject: [toaster] Different Greylisting Question, variables?
the greylisting-20060105.patch has this note:
"Greylisting patch against the new 0.8 beta netqmail patch
NOTE: This new release supports getting local_scan.c defnitions from
environment variables, so you will not have to recompile each time you
change them. tnx Joshua Megerman"
I'm probably missing something obvious, or reading that wrong, but where
can I change those variables, especially that time of 55 minutes? I know
where to change them before I run make, but if I'm reading that
correctly those numbers are stored some place I can change them without
the need to compile qmail again, I just can't seem to find it in the
code.
You place a line in /var/qmail/supervise/qmail-smtpd/run
i.e. export BLOCK_EXPIRE="13"
Bill
-----Original Message-----
From: Blake Carver [mailto:[email protected]]
Sent: Tuesday, November 21, 2006 6:06 AM
To: [email protected]
Subject: [toaster] Different Greylisting Question, variables?
the greylisting-20060105.patch has this note:
"Greylisting patch against the new 0.8 beta netqmail patch
NOTE: This new release supports getting local_scan.c defnitions from
environment variables, so you will not have to recompile each time you
change them. tnx Joshua Megerman"
I'm probably missing something obvious, or reading that wrong, but where
can I change those variables, especially that time of 55 minutes? I know
where to change them before I run make, but if I'm reading that
correctly those numbers are stored some place I can change them without
the need to compile qmail again, I just can't seem to find it in the
code.
相关阅读 更多 +
